Hi,
I’m encountering QuickTest failures on my LimeSDR. This test was conducted with RF antennae removed. What are my next steps?
user@debian:~$ LimeQuickTest
[ TESTING STARTED ]
->Start time: Mon Aug 24 18:21:02 2020
->Device: LimeSDR-USB, media=USB 3.0, module=FX3, addr=1d50:6108, serial=0009062000C40F38, HW=4, GW=2.23
Serial Number: 0009062000C40F38
Chip temperature: 62 C
[ Clock Network Test ]
->FX3 GPIF clock test
Test results: 23954; 27710; 31466 - PASSED
->Si5351C test
CLK0: 17554 / 17554 - PASSED
CLK1: 17554 / 17554 - PASSED
CLK2: 17554 / 17554 - PASSED
CLK3: 17554 / 17554 - PASSED
CLK4: 17554 / 17554 - PASSED
CLK5: 17554 / 17554 - PASSED
CLK6: 17554 / 17554 - PASSED
->ADF4002 Test
Result: 10 - PASSED
->VCTCXO test
Results : 5112912 (min); 5113038 (max) - PASSED
->Clock Network Test PASSED
[ FPGA EEPROM Test ]
->Read EEPROM
->Read data: 11 05 0F 11 05 0F 03
->FPGA EEPROM Test PASSED
[ LMS7002M Test ]
->Perform Registers Test
->External Reset line test
Reg 0x20: Write value 0xFFFD, Read value 0xFFFD
Reg 0x20: value after reset 0x0FFFF
->LMS7002M Test PASSED
[ RF Loopback Test ]
Note: The test should be run without anything connected to RF ports
->Configure LMS
SetPllFrequency: error configuring phase
SetPllFrequency: error configuring phase
SetPllFrequency: error configuring phase
SetPllFrequency: error configuring phase
SetPllFrequency: error configuring phase
SetPllFrequency: error configuring phase
SetPllFrequency: error configuring phase
SetPllFrequency: error configuring phase
SetPllFrequency: error configuring phase
SetPllFrequency: error configuring phase
LML TX phase search FAIL
Failed to set sample rate
->RF Loopback Test FAILED
=> Board tests FAILED <=
Elapsed time: 1.78 seconds
user@debian:~$